Use these 4 simple steps for breast implant insertion¹:

Step 1: TRIM

Following the trim guidelines printed on the funnel, use sterile straight-blade scissors to trim the distal end of the funnel to accommodate the implant. Printed trim guidelines are only suggested trim locations. Surgeon must ensure length of distal end of funnel is adequate to allow implant to pass through without damaging the implant. Length of distal end of the funnel after being trimmed does not dictate incision length. Surgeon should make the optimum incision based on the specific implant being used.

Step 2: HYDRATE

Fully immerse the funnel in a basin of sterile solution to render the inner surface slippery. Funnel should not be allowed to soak for longer than necessary, but should be kept moist to prevent inner hydrophilic coating from drying completely.

Step 3: LOAD

Insert the gel breast implant into the large end of the funnel using a   delivery technique. Use one hand to support the distal end and the other hand to advance the implant down the funnel to approximately 1 cm from the distal end.

Step 4: PROPEL

Insert the funnel approximately 1 cm through the incision and gently propel the breast implant into the surgical pocket using a  delivery technique.

Please refer to the Instructions for Use or the Instructional Video for additional information.

KELLER FUNNEL®2 accommodates a variety of gel breast implant shapes and sizes, including smooth round, textured round, shaped or anatomical. Textured shaped or high-profile breast implants may require a larger trim size¹. KELLER FUNNEL®2 is not indicated for use with saline implants.